Validate clean.
In ten seconds.
CleanTrust Touch 3500 Luminometer + CleanTrust Surface ATP Swab — an AOAC-certified ATP hygiene monitoring system for verifying surface and water cleanliness.
per test
10M+ records
with MagniSwab
standard ATP swabs
CleanTrust Swabs: Understanding the Difference
Choose the right swab for your validation needs
(fmol)
Surface Swab
Certified
Built to fit the workflow you already run.
Same form factor, same test motion, same 17cm swab format as the luminometer you’re benchmarking against — so switching consumables never means retraining staff.
Sample to Result – simple Testing Process
Take out the swab from the tube and rotate perpendicular to room temperature.
Take out the swab from the tube.
Zigzag the sampling area.
Put the swab into the tube.
Break the tip to release reagent into the sample tube.
Shake well.
Insert the swab into the detector.
Close the test chamber tightly and begin testing.
Four swabs, one luminometer.
Every CleanTrust swab shares the same 17cm format and has been validated to perform consistently across the Touch 3500, ENSURE®, ENSURE® Touch and SystemSure Plus – so switching consumables never means switching instruments or retraining staff.
Surface Swabs
AOAC certified. The CleanTrust Surface ATP Swab, used with the CleanTrust Touch 3500, is certified for performance testing and validated for consistent results.
MagniSwab
High sensitivity MagniSwab detects down to 0.1 fmol – designed for applications where increased sensitivity is required.
CleanTrust Water Free
Water-free formulation designed for applications where a low-volume reagent and consistent sampling performance are required.
CleanTrust Water Free
Water-free formulation for sampling points where rapid reagent performance and field-ready testing are required.
The data behind the certification.
AOAC certification applies to the CleanTrust Touch 3500 + CleanTrust Surface ATP Swab configuration only. CleanTrust swabs are also validated to run on ENSURE®, ENSURE® Touch and SystemSure Plus – so you can switch consumables without changing instruments, SOPs, software, or staff training – but certification itself is specific to the Touch 3500.
Switch consumables, not your programme.
The certified configuration covers CleanTrust Touch 3500 + CleanTrust Surface ATP Swab. CleanTrust swabs are also validated on ENSURE®, ENSURE® Touch and SystemSure Plus.
- Existing luminometers
- Standard operating procedures
- Software systems
- Staff training procedures
Lower running costs, same validated performance.
Switching to CleanTrust can help reduce consumable costs while maintaining validated performance and familiar workflows.
- Reduced consumable spend
- Improved workflow efficiency
- Validated performance
Alternative options for a quick
visual read.
When ATP isn’t needed, protein residue tests offer a fast visual alternative for quick checks.
If it’s green, it’s clean.Surface Protein Allergen Test Swab
Detects protein residues, including potentially allergenic proteins, on cleaned surfaces.
Surface Protein Test Swab
A ready-to-use swab for general protein residue detection on cleaned surfaces – quick and stable results in 1–10 minutes.
Ready to see it on your own surfaces?
LabTek Services can walk your team through a like-for-like comparison against your current ATP programme – no commitment required.